Assembly and Device Care

• Adjust the Perch Length
• Mount Your Birdfy Feeder Metal on a Wall
• Mount Your Birdfy Feeder Metal on a Pole
• Mount Your Birdfy Feeder Metal on a Tree
• Disassemble and Clean Your Birdfy Feeder Metal
• Reboot Your Birdfy Feeder Metal

Adjust the Perch Length

1. Loosen the knobs on both sides of the feeder.
2. Extend or retract the perch to your desired length.

Mount Your Birdfy Feeder Metal on a Wall

1. Use the drill template and an electric drill (15/64"", 6mm) to drill four holes.
2. Drive the provided plastic anchors into the holes. Skip this step if you are mounting on wood. Next, fasten the hanging bracket on the wall using the screws.
3. Hang the feeder onto the wall.

Mount Your Birdfy Feeder Metal on a Pole

1. Loosen the hose clip.
2. Wrap the hose clip around the hanging bracket.
3. Attach the hanging bracket to the pole.
4. Hang the feeder onto the pole.

Mount Your Birdfy Feeder Metal on a Tree

1. Slide the strap through the hanging bracket slots.
2. Wrap the strap around the tree.
3. Hang the feeder onto the tree.

Disassemble and Clean Your Birdfy Feeder Metal

1. Remove the camera from the camera compartment and disconnect it from the solar panel.
2. Seal the solar panel connector with the silicone cover.
3. Push the roof backward to disengage the magnet.
4. Remove the seed guard.
5. Use a brush and water to clean the feeder.

Reboot Your Birdfy Feeder Metal

If your camera goes offline or fails to stream, try the following steps:

1. Disconnect the camera from the solar panel or charger.
2. Use the provided ejector pin to poke the reboot hole for 1 second to shut down the camera completely.
3. Press and hold the power button for 3 seconds to turn on the camera.