Assembly and Device Care

• 1. Assemble the Birdbath
• 2. Change Nozzles
• 3. Assemble the Stand (If Applicable)
• 4. Clean the Birdbath

1. Assemble the Birdbath

1. Rotate the fountain into the center opening according to the markings on the basin.
2. Screw the 4 screws into the holes.
3. Rotate the connector and snap it into the 4 screws

2. Change Nozzles

1. For different spray patterns, assemble the nozzles as shown in the user manual.

3. Assemble the Stand (If Applicable)

1. Insert the pole into the stand
2. Secure the lanyard to the pole using the thumbscrew.
3. Attach the basin to the pole and secure it with the latch.
4. After filling with water, you can adjust the 4 screws to make the water surface parallel to the ground.

4. Clean the Birdbath

1. Pull out the latch (if you have the official stand, if no, skip to Step 2).
2. Remove the camera.
3. Dispose of the remaining water.
4. Clean the basin.