Assembly and Device Care

• Install the Extension Perch
• Mount Your Birdfy Feeder Bamboo on a Wall
• Mount Your Birdfy Feeder Bamboo on a Pole
• Mount Your Birdfy Feeder Bamboo on a Tree
• Disassemble and Clean Your Birdfy Feeder Bamboo

Install the Extension Perch

1. Position the extension perch onto the original perch.
2. Secure the extension perch by screwing it in place.

Mount Your Birdfy Feeder Bamboo on a Wall

1. Use the provided drill template to mark the locations of the holes, then use an electric drill (15/64", 6mm) to drill four holes.
2. Drive the provided plastic anchors into the holes. Skip this step if you are mounting on wood. Next, fasten the hanging bracket on the wall using the screws.
3. Align the mounting bracket on the back of the bird feeder with the hanging bracket, then hang the feeder securely on the wall.

Mount Your Birdfy Feeder Bamboo on a Tree

1. Slide the provided strap through the slots of the hanging bracket.
2. Wrap the strap around a tree trunk and fasten it by threading the end of the strap through the buckle. Make sure the lever on the buckle is facing upwards and that the strap goes through the buckle from the bottom to the top.
3. Align the mounting bracket with the hanging bracket and securely hang the bird feeder on the tree.

Mount Your Birdfy Feeder Bamboo on a Pole

1. Loosen the hose clips by turning the handle counterclockwise. Next, slide the hose clips through the slots of the hanging bracket. Align the bracket with the pole and secure it to the pole by tightening the hose clips.
2. Align the mounting bracket located at the back of the bird feeder with the hanging bracket, then securely hang the feeder on the pole.

Disassemble and Clean Your Birdfy Feeder Bamboo

1. Unscrew the extension perch from the feeder.
2. Open the camera compartment and take out the camera.
3. Remove the acrylic panels.
4. Push up the metal mesh from the bottom of the feeder and pull it out.
5. Use a brush and water to clean out any debris or clumped matter.
6. Dry the feeder thoroughly, then replace the components.