Assembly and Device Care

• Assemble Your Birdfy Nest Cyan/Ebony
• Mount Your Birdfy Nest Cyan/Ebony on a Wall
• Mount Your Birdfy Nest Cyan/Ebony on a Pole
• Disassemble and Clean Your Birdfy Nest Cyan/Ebony
• Reboot Your Birdfy Nest Cyan/Ebony

Assemble Your Birdfy Nest Cyan/Ebony

1. Open the cleanout door.
2. Connect the solar panel to the camera.
3. Screw the camera onto the camera bracket.
4. Close the cleanout door.

Mount Your Birdfy Nest Cyan/Ebony on a Wall

1. Use the provided drill template to mark the locations of the holes, then use an electric drill (15/64", 6mm) to drill four holes.
2. Drive the provided plastic anchors into the holes. Skip this step if you are mounting on wood. Next, fasten the hanging bracket on the wall using the screws.
3. Align the mounting bracket on the back of the birdhouse with the hanging bracket, then hang the birdhouse securely on the wall.

Mount Your Birdfy Nest Cyan/Ebony on a Pole

1. Loosen the hose clip by turning the handle counterclockwise.
2. Slide the hose clip through the slots of the hanging bracket.
3. Align the bracket with the pole and secure it to the pole by tightening the hose clip.
4. Align the mounting bracket located at the back of the birdhouse with the hanging bracket, then securely hang the birdhouse on the pole.

Disassemble and Clean Your Birdfy Nest Cyan/Ebony

1. Open the cleanout door.
2. Unscrew the camera and disconnect it from the solar panel.
3. Remove the metal mesh.
4. Clean every component with a brush and water.

Reboot Your Birdfy Nest Cyan/Ebony

If your camera goes offline or fails to stream, try the following steps:

1. Disconnect the camera from the solar panel or charger.
2. Poke and press the reboot button with an ejector pin for 1 second to shut down the camera completely.
3. Press and hold the power button for 3 seconds to turn on the camera.