Assembly and Device Care

• Assemble the Birdbath
• Change Nozzles
• Assemble the Stand (If Applicable)
• Clean the Birdbath
• Reboot Your Birdfy Bath Pro

Assemble the Birdbath

1. Rotate the fountain into the center opening according to the markings on the basin.
2. Screw the 4 screws into the holes.
3. Rotate the connector and snap it into the 4 screws

Change Nozzles

1. For different spray patterns, assemble the nozzles as shown in the user manual.

Assemble the Stand (If Applicable)

1. Insert the pole into the stand.
2. Secure the lanyard to the pole using the thumbscrew.
3. Attach the basin to the pole and secure it with the latch.
4. After filling with water, you can adjust the 4 screws to make the water surface parallel to the ground.

Clean the Birdbath

1. Pull out the latch (if you have the official stand, if no, skip to Step 2).
2. Remove the camera.
3. Dispose of the remaining water.
4. Clean the basin.

Reboot Your Birdfy Bath Pro

If your camera goes offline or fails to stream, try the following steps:

1. Disconnect the camera from the solar panel or charger.
2. Use the included ejector pin to poke and press the reboot hole for 1 second to shut down the camera completely.
3. Press and hold the power button for 3 seconds to turn on the camera.