Assembly and Device Care
- Assemble Your Birdfy Nest Wood
- Mount Your Birdfy Nest Wood on a Wall
- Mount Your Birdfy Nest Wood on a Pole
- Disassemble and Clean Your Birdfy Nest Wood
- Reboot Your Birdfy Nest Wood
Assemble Your Birdfy Nest Wood
- Take out the mesh floor from the accessory box and slide it into the birdhouse through the slot at the bottom.
- Connect the camera to the built-in solar panel.
- With the charging port facing outward, slide the camera onto the bracket inside the birdhouse. Then, secure the antenna with the clips.
Mount Your Birdfy Nest Wood on a Wall
- Use the provided drill template to mark the locations of the holes, then use an electric drill (35/127", 7mm) to drill two holes.
- Drive the provided plastic anchors into the holes. Skip this step if you are mounting on wood. Next, fasten the hanging bracket on the wall using the screws.
- Align the mounting bracket on the back of the birdhouse with the hanging bracket, then hang the birdhouse securely on the wall.
Mount Your Birdfy Nest Wood on a Pole
- Loosen the hose clip by turning the handle counterclockwise.
- Slide the hose clip through the slots of the hanging bracket.
- Align the bracket with the pole and secure it to the pole by tightening the hose clip.
- Align the mounting bracket located at the back of the birdhouse with the hanging bracket, then securely hang the birdhouse on the pole.
Disassemble and Clean Your Birdfy Nest Wood
- Detach the antenna from the clips.
- Remove the camera from the camera bracket.
- Disconnect the camera from the solar panel.
- Clear out any remaining nesting materials and remove the mesh floor.
- Use a brush and water to thoroughly clean each component.
Reboot Your Birdfy Nest Wood
If your camera goes offline or fails to stream, try the following steps:
- Disconnect the camera from the solar panel or charger.
- Use the included ejector pin to poke and press the reboot hole for 1 second to shut down the camera completely.
- Press and hold the power button for 3 seconds to turn on the camera.
