Assembly and Device Care

Adjusting the Clamp and Mount

1. Turn the wing nut to adjust the clamp. (Minimum width: 15 mm / 0.59 in; maximum width: 55 mm / 2.17 in)
2. The clamp has 1/4" and 3/8" threaded holes. Use the 1/4" hole with the included mounting arm, or the 3/8" hole for a separately purchased mounting accessory with a 3/8" screw.
3. Turn the wing nut to tighten or loosen both ball heads. When loosened, the ball heads can rotate freely to adjust the angle and direction.

Assembly

1. Tighten the mount to facilitate the following installation steps.
2. Screw the short end into the screw hole of the camera.
3. Screw the long end into the clamp's 1/4-inch threaded hole.
4. Secure the clamp to a pole or shepherd's hook.
5. Loosen the mount to adjust the camera angle, then point the camera toward the feeder you want to watch.
6. Connect the solar panel to the camera's charging port.
7. Make sure the antenna is upright.

Reboot Your Birdfy Cam 2 4K

If your camera goes offline or fails to stream, try the following steps:

1. Disconnect the camera from the solar panel or charger.
2. Switch the power button from ON to OFF, wait for 3 seconds, then switch it to ON again.