Assembly and Device Care

• Assemble Your Birdfy Feeder Cedar D
• Mount Your Birdfy Feeder Cedar D on a Wall
• Mount Your Birdfy Feeder Cedar D on a Pole
• Disassemble and Clean Your Birdfy Feeder Cedar D
• Reboot Your Birdfy Feeder Cedar D

Assemble Your Birdfy Feeder Cedar D

1. Mount the camera onto the camera bracket.
2. Screw the metal suet ball onto the bracket.
3. Place the metal mesh at the bottom of the feeder.
4. Connect the solar panel to the camera.
5. Attach the camera bracket to the feeder body.
6. Attach the suet ball bracket to the feeder body.

Mount Your Birdfy Feeder Cedar D on a Wall

1. Use the provided drill template to mark the locations of the holes, then use an electric drill (35/127", 7mm) to drill two holes.
2. Drive the provided plastic anchors into the holes. Skip this step if you are mounting on wood. Next, fasten the hanging bracket on the wall using the screws.
3. Align the mounting bracket on the back of the bird feeder with the hanging bracket, then hang the feeder securely on the wall.

Mount Your Birdfy Feeder Cedar D on a Pole

1. Loosen the hose clip by turning the handle counterclockwise.
2. Slide the hose clip through the slots of the hanging bracket.
3. Align the bracket with the pole and secure it to the pole by tightening the hose clip.
4. Align the mounting bracket located at the back of the bird feeder with the hanging bracket, then securely hang the feeder on the pole.

Disassemble and Clean Your Birdfy Feeder Cedar D

1. Disconnect the camera from the solar panel.
2. Remove the camera and the camera bracket.
3. Remove the suet ball bracket.
4. Remove the metal mesh.
5. Clean every component with a brush and water.

Reboot Your Birdfy Feeder Cedar D

If your camera goes offline or fails to stream, try the following steps:

1. Disconnect the camera from the solar panel or charger.
2. Press the reboot button for 1 second to shut down the camera completely.
3. Press and hold the power button for 3 seconds to turn on the camera.